It does a good job, it requires great attention to movements and proper cleaning in order to function correctly

It simply has a timer switch - basically, the kettle turns on, and when the water runs out, a thermal switch deactivates the kettle and turns on the fan for drying.
The function of the sterilization alone is simply to set the timer for a short time so that it does not switch to the fan (although it is not accurate, many times the water runs out earlier and it turns on for half a minute to a minute).

After 4 months, it broke and the fan immediately turns on without sterilization, even though it has normal water and is cold.
Also, when it was working, it would release water underneath during each sterilization (leakage? overflow?) even though the water did not exceed the max.

I would prefer something else that only does sterilization, without a fan, (or at worst, if sterilization was independent of drying).

The sterilization was not very fast but in the first stage (i.e. without drying) it was quite satisfactory. However, after almost 2 months of use, it started leaking water from the bottom and burned out.!!

Very good sterilizer indeed, very slow though... In full sterilization - drying mode it takes a whole hour

Very good sterilizer, very easy to use! I have been using it for 7 months now and it was the best purchase I have made. In the area where it fills with salt from frequent use, like all devices of this type, by adding a little water and vinegar they dissolve immediately. Personally, I highly recommend it without hesitation!

It was very good! I was thrilled! It dried them very well! It made them shiny! But it broke after 4 months! ????☹